Meshing between Channel
Article with picture can be view at http://www.moskaluk.com/meshing_between_channel.htm
My Lab results show I have a small mesh called MMN and have 13 nodes 8 are shown. Prior to deploying my mesh nodes I test them out and various scenario to ensure that everything is working. They use to call it "Burn Test" in the 80's.
I setup a channel 1 and channel 8. Nodes O-lab 20040601- and D-Experimental are on dev 94.
Wiana reporter that Channel 1 is Meshing with Channel 8. I've checked reporter on O-Lab and sure enough I can see channel 8 on D-Experimental . What I think is happening is either the topology graph is screwing up or something has been implemented that has made the units gone astray.
I did not investigate it any further. If you can duplicate this scenario please let me know.
I will reset the lab back to dev 88.
My Lab results show I have a small mesh called MMN and have 13 nodes 8 are shown. Prior to deploying my mesh nodes I test them out and various scenario to ensure that everything is working. They use to call it "Burn Test" in the 80's.
I setup a channel 1 and channel 8. Nodes O-lab 20040601- and D-Experimental are on dev 94.
Wiana reporter that Channel 1 is Meshing with Channel 8. I've checked reporter on O-Lab and sure enough I can see channel 8 on D-Experimental . What I think is happening is either the topology graph is screwing up or something has been implemented that has made the units gone astray.
I did not investigate it any further. If you can duplicate this scenario please let me know.
I will reset the lab back to dev 88.
1 Comments:
A
By mortgage company, at 6:41 AM
Post a Comment
Links to this post:
Create a Link
<< Home